Project

6
Attach Angle Brackets
2.1 – Lay Out Panel
Install the angled support brackets for the
paper roll.
2.2 – Cut Dowel
The dowel should be cut to 10”
2.3 – Drill Base
Predrill holes at ¾” from the side and 1-1/2”
from the bottom of the panel. Countersink the
backside to ensure panel lies flat on the wall after
hanging.
2.4 – Attach Paper Cutter
Using the washers as standoffs (to allow
paper to pass through) fasten ¾” X ¾” PVC with
wood screws.
Step 2 Cut Board Parts
Cut Dowel
Drill fastener holes
Attach Paper Cutter
Step 2: Cut Board Parts
2.1 – Lay Out Panel
Install the angled support brackets for the paper roll.
2.2 – Cut Dowel
The dowel should be cut to 10”.
2.3 – Drill Base
Predrill holes at ¾” from the side and 1-1/2” from the
bottom of the panel. Countersink the backside to ensure
panel lies at on the wall after hanging.
2.4 – Attach Paper Cutter
Using the washers as standoffs (to allow paper to pass
through) fasten ¾” X ¾” PVC with wood screws.
Attach Angle Brackets
Drill Fastener Holes Attach Paper Cutter
Cut Dowel
Attach Angle Brackets
2.1 – Lay Out Panel
Install the angled support brackets for the
paper roll.
2.2 – Cut Dowel
The dowel should be cut to 10”
2.3 – Drill Base
Predrill holes at ¾” from the side and 1-1/2”
from the bottom of the panel. Countersink the
backside to ensure panel lies flat on the wall after
hanging.
2.4 – Attach Paper Cutter
Using the washers as standoffs (to allow
paper to pass through) fasten ¾” X ¾” PVC with
wood screws.
Step 2 Cut Board Parts
Cut Dowel
Drill fastener holes
Attach Paper Cutter
Attach Angle Brackets
2.1 – Lay Out Panel
Install the angled support brackets for the
paper roll.
2.2 – Cut Dowel
The dowel should be cut to 10”
2.3 – Drill Base
Predrill holes at ¾” from the side and 1-1/2”
from the bottom of the panel. Countersink the
backside to ensure panel lies flat on the wall after
hanging.
2.4 – Attach Paper Cutter
Using the washers as standoffs (to allow
paper to pass through) fasten ¾” X ¾” PVC with
wood screws.
Step 2 Cut Board Parts
Cut Dowel
Drill fastener holes
Attach Paper Cutter
Attach Angle Brackets
2.1 – Lay Out Panel
Install the angled support brackets for the
paper roll.
2.2 – Cut Dowel
The dowel should be cut to 10”
2.3 – Drill Base
Predrill holes at ¾” from the side and 1-1/2”
from the bottom of the panel. Countersink the
backside to ensure panel lies flat on the wall after
hanging.
2.4 – Attach Paper Cutter
Using the washers as standoffs (to allow
paper to pass through) fasten ¾” X ¾” PVC with
wood screws.
Step 2 Cut Board Parts
Cut Dowel
Drill fastener holes
Attach Paper Cutter