Project

5
Step 1: Cut Board Parts
1.1 – Cut Board and Frame
Using the drawing as a guide, cut the board top and the
framing members to size. A few helpful hints:
If using factory cut panels for the top, confirm the
dimensions are correct and the board is square.
Stack the frame parts (4 of each length) and cut them on
a chop saw with a single cut, this will ensure accuracy.
1.2 – Drill Leg Mount & Pocket Holes
Drill all pocket holes NOTE: pay attention to the board
orientation. The boards should mirror each other.
Per the drawing – mark and drill the holes for the legs. If
you try to drill after assembly it will require a shorter than
standard drill bit
1.3 – Assemble Frame
Using PVC Cement and wood screws to assemble
the frame. Take note of the board orientation during
construction – pocket hole pointing down and on the
inside of the structure.
After assembled we cut a spacer block to gauge the
distance between the board top edge and the frame.
The spacer will be utilized.
Cutting Board and Frame
Assemble Frame and Pre-t
Drill Leg Mount
& Pocket Holes