Datasheet

Roxtec ® and Multidiameter ® are registered trademarks of Roxtec in Sweden and/or other countries.
Roxtec International AB
Box 540, 371 23 Karlskrona, SWEDEN
PHONE [phone], FAX [phone]
EMAIL [e-mail], www.roxtec.com
DISCLAIMER
”The Roxtec cable entry sealing system (”the Roxtec system”) is a modular-
based system of sealing products consisting of different components. Each
and every one of the components are necessary for the best performance of
the Roxtec system. The Roxtec system has been certified to resist a number
of different hazards. Any such certification, and the ability of the Roxtec system
to resist such hazards, is dependent on all components that are installed as a
part of the Roxtec system. Thus, the certification is not valid and does not apply
unless all components installed as part of the Roxtec system are manufactured
by or under license from Roxtec (“authorized manufacturer”). Roxtec gives no
performance guarantee with respect to the Roxtec system, unless (I) all compo-
nents installed as part of the Roxtec system is manufactured by an authorized
manufacturer and (II) the purchaser is in compliance with (a), and (b), below.
(a) During storage, the Roxtec system or part thereof, shall be kept indoors
in its original packaging at a temperature not exceeding +70°C/+158°F and
not below -40°C/-40°F.
(b) Installation shall be carried out in accordance with Roxtec installation in-
structions in effect from time to time.
The product information provided by Roxtec does not release the purchaser of the
Roxtec system, or part thereof, from the obligation to independently determine
the suitability of the products for the intended process, installation and/or use.
Roxtec gives no guarantee for the Roxtec system or any part thereof and
assumes no liability for any loss or damage whatsoever, whether direct, in-
direct, consequential, loss of profit or otherwise, occurred or caused by the
Roxtec systems or installations containing components not manufactured by
an authorized manufacturer.
Roxtec expressly excludes any implied warranties of merchantability and fitness
for a particular purpose and all other express or implied representations and
warranties provided by statute or common law. User determines suitability of
the Roxtec system for intended use and assumes all risk and liability in con-
nection therewith. In no event shall Roxtec be liable for consequential, punitive,
special, exemplary or incidental damages.”
ASS2005003301 ver_1.4/GB/0944/olaher
Disassembly
Reverse order
Insert the modules according to
your installation plan (transit plan).
Start with the largest modules.
Tighten the compression unit to
seal the frame. Recommended
torque 8-12 Nm.
Note
 For optimum reliability, wait 24 hours or longer after installation before exposing the cables/pipes to strain or pressure.
 To be used with: CM components.
 Cables shall go straight through the frame.