Owner Manual

50mm
Drill
Drill pilot holes in
the side panel top
frame for these
screws.
50mm
30mm
Felt batten
length 1200mm
Felt batten
Ensure the top
edge of each roof
panel is located at
the apex.
Felt batten
5. Apex panels
Place an apex panel on top of a side panel, make sure the T&G cladding of the apex fits correctly into the T&G of the cladding of the side panel. Secure in place using 3 x 50mm
screws. Screw up through the top frame of the side panel into the bottom frame of the apex. Attach the remaining apex to the other side panel in the same way.
10mm
Felt
nails
Roof
7. Roof felt
Place one length of felt over the back roof. At sides and along the lower edge of the roof leave an overhang of felt of at least 45mm. Fold down the felt along the lower edge
and secure to the felt batten using 15 x 10mm felt nails evenly spaced. Dress the felt over the roof ridge, tension and secure along the edge using 3 x 10mm felt nails. position
the second piece of felt in the same way as the first on the front of the roof. Attach to the felt batten using 15 x 10mm felt nails, tension over the roof and secure with 15 x
10mm felt nails. At the sides dress down the felt and secure to the panels using 6 x 10mm felt nails per end. Using a sharp knife trim off excess felt.
10mm
Felt
nails
30mm
10mm
Felt
nails
10mm
Felt
nails
Roof purlin
length 1178mm
Drill
Drill pilot holes For
the 50mm screws.
6. Roof
Insert the Roof purlin into the rebate at the top of the apex panels. Drill a pilot holes through the apex cladding into the ends of the purlin, secure in place using 2 x 50mm
screws. Screw in through the pilot hole in the apex cladding into the ends of the purlin. Nail one felt batten flush to a long edge of each roof section using 6 x 30mm nails,
nail through the roof and into the batten. Position the roof panels onto the assembly, make sure the top edges are located at the apex. Secure with 12 x 30mm nails per
roof section, through the roof and into the top frames of the building.