Owner Manual

1. Floor section
Attach the floor bearers to the floor using 6 x 30mm nails per bearer. Have the two outer bearers flush with the edge of the floor and the two middle bearers equally
spaced in between. Nail through the floor into the bearer.
30mm
Important Information: To validate the guarantee the playhouse should be
fitted with four additional bearers 50 x 50 x 1178mm, fitted in the opposite
direction as shown.
Additional bearers
and bearer fixings
are not included in the kit.
25mm
Small tab
to door.
Large tab to
door frame.
Front panel
32mm
19mm
50mm
50mm
Back panel
Side panel
Panel frames
rest on floor.
Panel cladding
overhangs floor
edge.
Back panel
Door panel
Side panel Side panel
Drill
Drill pilot
holes for the
window
screws.
2. Door panel
Attach the three small tabs of the hinge to the door as shown using 2 x 25mm screws per tab. Open the hinge and secure the large tab to the door frame using 5 x 25mm
screws per tab as shown below. Put the windows into place on the front panel, Secure each window using 4 x 32mm. Screw through the window into the framework of
the front panel. Secure the door handle using 4 x 19mm black roundhead screws as shown below.
4. Walls to floor
Ensure the panels are sitting square on the floor. Secure using 3 x 50mm nails per panel, nail through the panel frame through the floor and into the floor bearers.
50mm
50mm
50mm
Floor bearers
Floor
Panel frames
Side panel
Back panel
3. Wall panels
Position the back panel and the side panel as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge. Ensure square and
secure using 2 x 50mm screws through the frame of the back panel into the frame of the side panel. Repeat for the door panel and then add the other side panel in the
same way.
1160mm
1120mm
Use this diagram to check the correct
orientation of the corners
Important