Specifications

5
Problem: Possible Cause: Corrective Action:
6) Stapler intermittently
misres staples
1. Worn washer See corrective action for problem (2).
2. Incorrect staples. Check the staples, make sure the correct staple type is loaded in the
stapler.
3. Debris in magazine cham-
ber prevents pusher from
pushing staples forward
smoothly.
Slide the magazine cover off the stapler (See Step 1 &
2 in How to Replace Pusher and Pusher Spring).
With a soft cloth or air gun, clean the pusher, magazine chamber and the
magazine cover.
4. Worn pusher and/or push-
er spring.
See How to Replace Push and Pusher Spring. Or call Rowley
Company.
5. Low air pressure See corrective action for problem (2).
7) Staples appear stuck.
Staples are not feeding
properly
1. Incorrect staples. See corrective action for problem (6).
2. Debris in magazine
chamber.
See corrective action for problem (6).
3. Worn pusher and/or push-
er spring.
See corrective action for problem (6).
8) Stapler is jamming 1. Incorrect staples. See corrective action for problem (6).
2. Debris in magazine
chamber.
See corrective action for problem (6).
3. Shooting one staple on
top of another staple
Do not shoot one staple over other staples.
4. Worn pusher and/or push-
er spring.
See corrective action for problem (6).
5. Staples jam in the nose
tip.
The driver guide (part # 32) is bent or the latch spring (part # 39) is too
loose. Call Rowley Company.
9) Stapler has an air leak See corrective action for problem (4).
10) Stapler spits water
and/or rust
1. Air compressor tank has
condensation water and/or
is rusted.
Empty out the air compressor tank and purge the air supply line according
to the manufacturer’s instruction. Add a lter to the compressed air line
(Fig. 3).
11) Stapler magazine cov-
er slides off the stapler.
Pusher and pusher spring
falls out.
1. The screw holding the L
bracket is loose and falls off.
See How to Replace Pusher and Pusher Spring. Or call Rowley Co.
To prevent this problem from happening again, check the screw (Fig. 6,
page 3) before use and make sure the screw is tight.
TROUBLESHOOTING (Cont.):