Use and Care Manual

8 9
- Before rinsing the boiler/rinsing the anti-calc collector (depending on the
model), wait until the appliance is completely cold and has been unplugged
for at least 2 hours before unscrewing the boiler rinse cap/ the scale collector
cover.
- Warning: if the boiler cap or the boiler rinse cap (depending on the model),
is dropped or severely knocked, have it replaced by an Approved Service
Centre, as it may be damaged.
- Never fill the boiler directly from the tap.
- The boiler cap must not be opened during use..
SAVE THESE INSTRUCTIONS
TROUBLESHOOTING
Problem Possible Causes Solutions
Your iron is
producing
little or no
steam.
You have just
lled the tank or
changed the anti-
calc cartridge, or
you have just started
using it.
Press the steam control
button continuously for
a few minutes, pointing
it away from your linen
in order to prime the
pump.
There is no anti calc
cartridge in the
appliance or it is not
properly installed.
Make sure the anticalc
cartridge is installed
and locked in its
compartment.
Steam cannot be
produced at the
temperature you
have selected.
Set the thermostat
control in the coloured
zone (••• or MAX).
The water tank is
empty.
Fill the tank.