User Guide

5
USING FOR THE FIRST TIME
M
Please read the instructions for use and the Important Safety
Instructions carefully.
M
It is normal for a small amount of smoke to be produced the first
time the appliance is used. This will quickly disappear.
M
When the appliance is plugged in and
thermostat control dial is moved from
the minimum setting, the soleplate
heats. Do not touch or remove the sole-
plate cover without letting the appliance
cool down.
M
During use or while unit is heating or
cooling, do not rest appliance on its sole-
plate. Place product on its side on a firm,
heat resistant, flat surface, as soleplate
will be hot.
M
As the appliance heats the housing becomes warm.This is normal.
FILLING THE WATER TANK
Before plugging in the Steam 'n Press fill the water tank (C) with water
as follows:
Remove the water tank
M
To remove the water tank, hold on to
the bottom half of the handle and slide
the top half of the handle away from
the appliance as shown.
Filling the water tank
M
Remove cap, fill the tank with ordinary
tap water and close the cap.
Replacing the water tank
M
Put the full water tank back into the
unit, by sliding the lower handle back
into the top half of the handle until it is
firmly in place.
Adding water during use
M
Always unplug the appliance and wait for it to cool down before
removing the water tank.
M
Handle with care as unit will remain hot for a considerable time.
M
Fill as indicated in water tank filling section.
M
Plug in the appliance and wait approximately one minute to ensure
your Steam 'n Press is fully reheated before using it.