ARTEC 16. 17. 17a. .5 .18 17b. 17c. 2. 3. 4. .6 1. .19 .7 E N G L I S H .8 .9 .20a .20b .10 .11 15. .14 .13 .12 20. 20c. Ref.
Thank you for your confidence, we are sure that the ARTEC vacuum cleaner you have bought will give you complete satisfaction. Take it out of the packaging and unpack all of the accessories. Your vacuum cleaner includes: 1. Cord rewind pedal 2. Dustbag full indicator (according to model). 3. Electronic power control (according to model): a) 2 positions, Eco/Max b) Eco Max control button c) Infrared remote control 4. ON/OFF pedal 5. Accessory compartment lid 6. Accessory compartment 7. Dust bag support 8.
HINTS AND PRECAUTIONS ▲ Before each use, the supply cord should be completely unwound. Do not allow it to become trapped or pulled over sharp edges. Never lift the apparatus by its cord. ▲ If you use an extension cord, make sure that it is in perfect condition and appropriate to the power rating of your appliance. ▲ Never unplug the appliance by pulling on the cord. ▲ Only use original Rowenta or Wonderbag accessories and filters. ▲ Check that the all the filters are properly in place.
the suction hose: press and pull. Open the cover • Press on the bag support to unfasten • Put back in place and close the cover again. Note: The lid will not close unless you have fitted a new bag. Important ! Check, clean and replace the various filters regularly. Clean the foam air-intake filter. Turn off ARTEC temporarily. (model with remote control) • Press the PAUSE button; the infrared pickup light stays on, the setting is memorised, and the appliance remains powered ON.
Clean the HEPA Important: When using the HEPA FILTER SYSTEM, do not forget to remove the air outlet foam filter and the micro-active filter. • Remove the filter cartridge. Remove the HEPA filter. • Place it in an upright position and slide the mount on the combination nozzle into the tube holder. Subject to modifications! FOR YOUR SAFETY: • Change it every 9 to 12 months (depending on the frequency of use). Clean ARTEC.
WHAT TO DO IF : Important! As soon as your vacuum cleaner starts to malfunction, and before performing any checks: • Stop the appliance by pressing the Start/Stop switch . • Unplug the appliance. ARTEC will not start. • The product is not connected to the mains. . . . Check that the product is correctly plugged in. Check the fuse and your mains supply circuit breaker. ARTEC does not suck. • Either a tool or the hose is blocked . . . . . . . . . . Unblock the tool or the hose.
