Couv DZ500 correc 8/03/06 10:54 Page 2 GB D F I SP P RF mod. DZ5020 GR UA www.rowenta.
Couv DZ500 correc 8/03/06 10:54 Page 3 6 5 4 3b* 7 3a 3c 8 3d* 3 9 10b 2 1 10a A U T O-OFF 10c 10d 11 12 13
Couv DZ500 correc 8/03/06 10:54 Page 4 fig. 1 fig. 2 fig. 3 fig. 4 fig. 5 fig. 6 NO fig. 7 NO A U T O- O F F fig. 10 fig. 8 fig. 9 fig. 11 fig.
Couv DZ500 correc 8/03/06 10:54 Page 5 fig. 13 fig. 14 fig. 15 fig. 16 fig. 17 fig. 18 NO fig. 19 fig.
Couv DZ500 correc З праски витiкає вода. 8/03/06 10:54 Занадто часте натискання кнопки парового удару. Page 6 Робiть бiльшi iнтервали мiж натисканнями кнопки. Використовується Використовуйте тiльки необроблену дистильована/демiнералiзов воду з-пiд крана або наполовину ана або пом’якшена вода. розводьте воду з-пiд крана дистильованою/ демiнералiзованою водою. Виконайте процедуру Self Clean (самоочищення), а потiм почистiть праску.
DZ5000-1103899452-Mars06 9/03/06 11:44 Page 3 DESCRIPTION 1 2 3 Spray nozzle Filling inlet (with slide-button opening) Variable steam control a Dry ironing b Steam max.
DZ5000-1103899452-Mars06 9/03/06 11:44 Page 4 – the appliance is obviously leaking. In these cases the appliance should be returned to an approved Rowenta Customer Service Centre for repair. (See enclosed Service Centre addresses.) Repairs to electrical appliances may only be carried out by specialists. Improperly carried out repairs can cause serious danger to users. To avoid danger to users, a defective or damaged supply cord may only be replaced by an authorised Rowenta Customers Service Centre .
DZ5000-1103899452-Mars06 9/03/06 11:44 Page 5 or demineralised water or rain water should not be used in your iron. Also do not use boiled, filtered or bottled water. 3 • Using for the first time Plug in the iron (fig.2) and set the temperature control dial (fig.3) to ••• to heat the appliance. A little smoke and a slight smell may be emitted, but this is only temporary. Unplug the iron (fig.4) and fill the water tank (§ 4 Filling the water tank).
DZ5000-1103899452-Mars06 9/03/06 11:44 Page 6 Fabric Temperature control Synthetic fibres, e.g. viscose, polyester… • Silk, wool •• Cotton, linen ••• Ironing label Electronic temperature control*: The traffic lights tell you whether the soleplate is at the selected temperature (fig.10). YELLOW GREEN RED AUTO- OFF The soleplate is still too cold for the selected material. The soleplate is at the right temperature for the selected material.
DZ5000-1103899452-Mars06 9/03/06 11:44 Page 7 quantity only when the iron is at temperature setting •••. Auto Steam function* Set the steam button to (fig.13) and the steam quantity will adjust automatically to the soleplate temperature. 8 • Shot of steam (from temperature setting •• upwards) IMPORTANT Leave an interval of 4 seconds between each shot and wait until the flow of steam is finished before standing the iron on its heel.
DZ5000-1103899452-Mars06 9/03/06 11:44 Page 8 AFTER USE 13 • Emptying Unplug the iron (fig.4), pour away remaining water (fig.17) and set steam control to . Open and close the steam control several times (fig.18) to prevent the valve hole into the steam chamber from scaling or blocking up. 14 • Storing Allow the appliance to cool down before storing the iron standing on its heel (fig.19). IMPORTANT Do not wind the cord around the hot soleplate. Never store your iron placed down on the soleplate (fig.
DZ5000-1103899452-Mars06 9/03/06 11:44 Page 9 Move the steam control to position after approx. 1 minute. Plug in the iron and allow the iron to heat up again. Wait until the remaining water has evaporated. Unplug from the mains and allow the iron to fully cool down. When cool, the soleplate can be wiped with a damp cloth. TIP Use the Self Clean function approx. every 2 weeks. If the water is very hard, clean the iron weekly.
DZ5000-1103899452-Mars06 None or too little steam is being emitted. Brown streaks come through the holes inthe soleplate and stain the linen. Iron is leaking. 9/03/06 11:44 Page 10 Steam control set on dry position . Turn the steam control to the required setting area. Not enough water in the water tank. Fill the water tank. Anti-Drip* is active (§ 11). Wait for the soleplate to reach the correct temperature. Residues in the steam chamber or on the soleplate.
Couv DZ500 correc 8/03/06 10:54 1103899452 Page 1
