User Manual

2
at each location before using the appliance. For connection to a 220-240 volt
supply, use a suitable attachment plug adapter of the proper configuration for
the power supply receptacle.
The use of other accessory attachments than those provided by Rowenta is not
recommended and may result in fire, electric shock or personal injury.
For dual voltage* appliance:
a. Be sure dual voltage selector is in correct voltage position before operating.
b. Before plugging in, read the information about dual voltage operation contained
in the instruction section of this manual.
c. This appliance was set at the factory to operate at 110-120 Volts.
Refer to operating instructions section of this manual for conversion to 220-240 Volt
operation.
d. Incorrect setting of voltage can result in damage to the appliance.
* depending on model
SAVE THESE INSTRUCTIONS
1. Removable fabric brush
2. Removable lint pad
3. Steam trigger
4. Removable water tank
5. Storage hook
6. Electrical cord
7. Thermostat indicator light
8. Dual voltage selector
110-120V or 220-240V
(depending on model)
DESCRIPTION
Before use
Please read the instructions for use and
Important Safeguards carefully.
• Remove any packaging from the ap-
pliance.
• Do not plug in or turn on until assembly
is complete.
Dual voltage
(depending on model)
• The appliance can work on both, 110-120V
or 220-240V, AC systems. Be sure the dual
voltage selector is in the correct voltage
position before plugging in. To do this,
switch the selector which is above the
handle to the right position -
fig.6 bis.
• This is a 110-120V dual voltage appliance
and may be used in the United States and
abroad without an electrical converter.
An adapter plug may be necessary when
using appliance in foreign countries.
• If needed, plug the steambrush into the
correct adapter plug for the specific coun-
try and plug assembly into electrical out-
let.
It is normal for a small amount of
smoke to be produced the first time
the appliance is used. This will
quickly disappear.
Warning! Never switch selector
while unit is plugged in.
Dual voltage selector in wrong
voltage position:
If the voltage selector is set to 220-
240V in a 110-120V supply, the
performance of the steambrush will
be reduced.
Never set the voltage selector to 110-
120V in a 220-240V supply as this
can damage the product.
1800129617 DR6000 U1_110 x 154 30/10/13 10:45 Page2