User Manual

• Remove the water tank by pushing it backwards.

• Put the tank into the handle until it snaps in.

• Unplug the rubber stopper.

• Fill the watertank to the top with water and close it securly.

• Put the tank into the handle until it snaps in.

• Completely unwind the power cord. Plug in your steam brush.

It is normal for a small amount of smoke or steam to be produced the

first time the appliance is used. This will quickly disappear.

Use

Important: Heat concentrates the elements contained in water

during evaporation. The types of water listed below may contain

organic waste, mineral or chemical elements that can cause

spitting, brown staining, or premature wear of the appliance:

water from clothes dryers, scented or softened water, water from

refrigerators, batteries, air conditioners, rain water, boiled, filtered

or bottled water. Also use distilled or demineralised water only as

advised above.

• Once the appliance is plugged in, the light will

turn on. Set the steam control dial to the desired

setting.

• After approximately 30 seconds, the light will

turn off indicating the steambrush, has reached

working temperature.