Operation Manual
1. Place the iron’s temperature control to the type
of fabric to be ironed (6).
•
Synthetics (low temperature)
••
Silk/wool (medium temperature)
•••
Cotton/Linen (high temperature)
2.The iron temperature control light turns on.
Be careful ! the steam generator is ready when the iron temperature control light goes out and
when the green « steam ready » light stays continuous.
3.
Adjust the steam output control dial located on the control panel (7), eg : less steam for low temperatures.
Note : It is normal for the connection cord to become warm during use.
5 • USINGYOUR STEAM GENERATOR
GB
• Flashing green light : the water is heating up in
the boiler.
• Continuous green light : steam is ready for
use.
• Continuous red light :
the water tank is empty.
• Orange “boiler rinse” light flashes : your boiler needs rinsing.
Note: the appliance must be cold (see section 11).
• “Restart” button:
- to be pressed briefly after each refill of the water tank to start ironing again (see paragraph 6),
- to be held pressed for 2 or 3 seconds after rinsing the boiler (see paragraph 11).
4 • OPERATING THE CONTROL PANEL
c
o
t
t
o
n
-
l
i
n
e
n
s
i
l
k
-
w
o
o
l
s
y
n
t
h
e
t
i
c
s
M
I
N
(6)
(7)
Type of fabric
Setting temperature
control
Setting steam
output control dial
c
o
t
t
o
n
-
l
i
n
e
n
s
i
l
k
-
w
o
o
l
s
y
n
t
h
e
t
i
c
s
M
I
N
c
o
t
t
o
n
-
l
i
n
e
n
s
i
l
k
-
w
o
o
l
s
y
n
t
h
e
t
i
c
s
M
I
N
•
(Low
temperature)
c
o
t
t
o
n
-
l
i
n
e
n
s
i
l
k
-
w
o
o
l
s
y
n
t
h
e
t
i
c
s
M
I
N
••
(Medium
temperature)
•••
(High
temperature)
Synthetics
Silk / Wool
Cotton / Linen
SETTINGTHETEMPERATURE CONTROL AND STEAM OUTPUT CONTROL DIAL ACCORDINGTO
THETYPE OF FABRIC TO BE IRONED:
1800113332 GRB DG9020 30 40:1800113332 GRB DG9020 30 40 14/03/08 9:04 Page 5