User`s guide

RN-WIFLYCR-UG
www.rovingnetworks.com Version 1.2r 4/30/13 page 93
To enable these modes, use the set q sensor <mask> command.
EXAMPLE 4-20: SAMPLE ALL SENSOR INPUTS
4.9.2 Using the Built-In Sensor Power
The modules contain an on-board sensor power pin, which is controlled by the set q
sensor <mask> command. <mask> is a bit mask value that determines which sensor
pins to sample when sending data using the UDP broadcast packet or the HTTP auto-
sample function. See “set q sensor <mask>” on page 21 for more details.
Firmware versions 2.23 and higher support the set q power <value> command. This
command sets an 8-bit register with two 4 bit nibbles that automatically turns on the
sensor power. See “set q power <value>” on page 21 for more details on using this
command.
set q sensor 0xff // Sample all sensor inputs
Note: In versions of firmware prior to 2.23, this command is named set option
sensor.