User`s guide

RN-WIFLYCR-UG
www.rovingnetworks.com Version 1.2r 4/30/13 page 68
Use the show time command to see the current time and uptime as shown below:
<2.23> show t
Time=08:43:10
UpTime=10 s
To set the time, use the time command:
<2. 23> show t
Time NOT SET
UpTime=8 s
<2. 23> time
<2. 23> show t
Time=08:51:31
UpTime=15 s
The module can also be configured to get the time whenever it powers up using the set
time enable 1 command. If you set the time enable to a value greater than 1, the mod-
ule pulls the time continuously every <value> minutes.
For example, to configure the module to get time upon power up, see the following
example:
<2. 23> set time enable 1
AOK
<2. 23> get time
ENA=1
ADDR=129.6.15.28:123
ZONE=7
To view a complete listing of the time variable, use the following command:
<2. 23> show t t
Time=09:02:10
UpTime=653 s
RTC=1293567548
Restarts=1
Wake=6
RAW=2345ab
Note: The module must be associated with a network for the module to contact
the sNTP server.
Note: The RAW value is the 64-bit hex RAW value of the RTC, which ticks at
32,768 Hz.