User`s guide

RN-WIFLYCR-UG
www.rovingnetworks.com Version 1.2r 4/30/13 page 52
FIGURE 3-3: MODULE’S NETWORK NAME
2. Launch your web browser.
3. Type http://config to go to the home page of web server running on the module.
The page has two tabs displayed by default:
• Network Configuration—Used to set the AP?s SSID and passphrase.
• Information—Displays information about the WiFly module. This tab displays
the following information:
- WiFly module’s MAC address
- Module type (RN131 or RN171)
- List of files on the file system
- Battery strength
4. Click the Network Configuration tab (see Figure 3-4). In this tab you configure the
module’s network settings (SSID and passphrase). Configure these settings
using the following steps:
a) Enter your network’s SSID in the Access Point SSID box.
Alternatively, click the Refresh List button. The module scans for networks
and displays a list of found networks. Select your network from the Available
Access Points list or type it in the Access Point SSID box. Clicking an SSID
displays a drop-down menu with more information about that network, such
as channel, RSSI, security mode (WEP, WPA, WPA2), capabilities, WAP
configurations, WPS configuration, and the AP’s MAC address (also called
BSSID). If you do not see your desired access point in the list, click Refresh
List to scan again.