User`s guide

RN-WIFLYCR-UG
www.rovingnetworks.com Version 1.2r 4/30/13 page 117
Index
Symbols
.mif, upgrading with.................................................. 84
$$$ ........................................................................6
, 40
escape buffer ...................................................... 6
A
access point
associating........................................................ 73
scan in ad hoc mode......................................... 91
supported........................................................ 101
access point mode ................................................... 45
action commands..................................................... 40
ad hoc mode .......................................................30
, 89
beacon .............................................................. 10
configuring ........................................................ 90
default network settings ...................................... 7
display settings ................................................. 35
enable in hardware ........................................... 90
enable in software............................................. 90
probe setting ..................................................... 10
scan for APs ..................................................... 91
ad hoc network......................................................... 89
Airlink ..................................................................... 101
Airport Express ...................................................... 101
alternate functions.................................................... 22
alternate GPIO functions.......................................... 62
analog interface pin value ........................................ 38
analog interface values, show multiple .................... 38
analog sensor .......................................................... 92
analog-to-digital convertor ....................................... 80
AP mode .................................................................. 45
connect to module ............................................ 47
default settings.................................................. 46
enable in hardware ........................................... 45
enable in software............................................. 46
enabling ............................................................ 45
GPIO alternative functions................................ 48
last device connected ....................................... 48
link monitor ....................................................... 48
route data between clients................................ 48
view associated devices ................................... 48
AP, associating ........................................................ 73
AP, scan for ............................................................. 42
apmode command ................................................... 40
APs, supported ...................................................... 101
associate, AP ........................................................... 73
auto pairing, UDP..................................................... 72
auto wake timer........................................................ 27
auto-connect timer ................................................... 22
auto-connect timers ................................................. 57
auto-join feature ....................................................... 45
automatic connections ............................................. 75
B
baud rates ................................................................ 29
bit-mapped register
ip flags............................................................... 17
ip protocol ......................................................... 18
ip tcp-mode ....................................................... 19
opt format.......................................................... 19
show connection ............................................... 37
sys trigger ......................................................... 26
uart mode.......................................................... 29
boot image ............................................................... 44
boot-up, timing ......................................................... 99
broadcast, packet byte format.................................. 73
broadcast, UDP........................................................ 72
browser disconnect timer ......................................... 55
Buffalo networks..................................................... 101
C
channel mask ........................................................... 33
Cisco ...................................................................... 101
clock, real-time ......................................................... 67
close......................................................................... 40
close string ............................................................... 12
CMD ........................................................................... 6
command mode ................................................... 6
, 40
command character setting............................... 12
exit .................................................................... 40
terminal emulator ................................................ 7
command, quick reference..................................... 103
commands
overview.............................................................. 9
reboot after.......................................................... 9
set ..................................................................... 10
shorthand ............................................................ 9
syntax.................................................................. 9
types ................................................................... 9
configuration............................................................... 6
ad hoc mode ....................................................... 7
default ............................................................... 95
using configuration web server ......................... 51
configuration web server .................................... 49
, 50
configure module .............................................. 51
invoke in hardware............................................ 50
invoke in software ............................................. 51
LED status ........................................................ 51
set sys launch_string ........................................ 23
using ................................................................. 50
configuring ad hoc mode.......................................... 90
connect to module in AP mode ................................ 47
connection
automatic .......................................................... 75
display status .................................................... 37
making .............................................................. 75