User`s guide

RN-WIFLYCR-UG
www.rovingnetworks.com Version 1.2r 4/30/13 page 107
close Disconnects a TCP connection.
exit Exits command mode.
factory RESET Loads the factory defaults into the module’s RAM and writes the settings to the standard
configuration file. You must type the word RESET in capital letters.
join <string> Instructs the WiFly module to join the network indicated by <string>.
join # <value> Use this command to join a network that is shown in the scan list, where <value> is the
entry number listed for the network in the scan list.
leave Disconnects the module from the access point to which it is currently associated.
lookup <string> Causes the module to perform a DNS query for host name <string>.
open <address> <value> Opens a TCP connection to <address>, where <value> is the port number.
ping <string> <value> Pings a remote host, where <string> is a parameter setting and <value> is the number of
pings. The default is 1 packet.
reboot Forces the module to reboot (similar to a power cycle).
run Runs an application using ASCII commands.
scan <value> <char> Performs an active probe scan of access points on all 13 channels. The default is 200
ms/channel.
sleep Puts the module to sleep.
time Sets the real-time clock by synchronizing with the time server specified with the time
server (
set time) parameters.
TABLE D-5: FILE I/O COMMANDS
Command Description
del <string> <value> Deletes a file.
load <string> Reads in a new configuration file.
ls Displays the files in the system.
save <string> Saves the your configuration settings to a file.
boot image <value> Makes a file represented by <value> the new boot image.
ftp update <string> Deletes the backup image file, retrieves a new image file, and updates the boot pointer to
the new image.
TABLE D-4: ACTION COMMANDS
Command Description