User`s guide

RN-WIFLYCR-UG
www.rovingnetworks.com Version 1.2r 4/30/13 page 106
set wlan ssid <string> roving1 Sets the SSID with which the module associates.
set wlan tx <value> 0 Sets the Wi-Fi transmit power, where <value> is a decimal
number from 1 to 12 that corresponds to 1 to 12 dBm.
set wlan user <string> – Reserved for future use.
TABLE D-2: GET COMMANDS
Command Description
get adhoc Displays the ad hoc settings.
get broadcast Displays the broadcast UPD address, port, and interval.
get com Displays the communication settings.
get dns Displays the DNS settings.
get everything Displays all of the configuration settings, which is useful for debugging.
get ftp Displays the FTP settings.
get ip <char> Displays the IP address and port number settings, where <char> is the optional parame-
ter a. Using <char> returns the current IP address.
get mac Displays the device’s MAC address.
get option Displays the optional settings such as the device ID.
get sys Displays the system settings, sleep and wake timers, etc.
get time Displays the time server UDP address and port number.
get wlan Displays the SSID, channel, and other WLAN settings.
get uart Displays the UART settings.
ver Displays the firmware version.
TABLE D-3: STATUS COMMANDS
Command Description
show battery Displays current battery voltage, and is only applicable to Roving Networks’ battery-pow-
ered products such as the RN370 and temperature sensors (ISENSOR-CB).
show connection Displays the connection status in the hex format 8<XYZ>.
show io Displays the GPIO pins’ level status in the hex format 8<ABC>.
show net <char> Displays the current network status, association, authentication, etc., where <char> is the
optional parameter n. Using the n parameter displays only the MAC address of the
access point with which the module is currently associated.
show q <value> Displays the value of the analog interface pin, where <value> is 0 to 7.
show q 0x1<mask> Displays multiple analog interface values simultaneously.
show rssi Displays the last received signal strength.
show stats Displays the current statistics, packet RX/TX counters, etc.
show time Displays the number of seconds since the module was last powered up or rebooted.
TABLE D-4: ACTION COMMANDS
Command Description
$$$ Use this command to enter command mode.
apmode <bssid> <chan-
nel>
Creates a soft AP network.
TABLE D-1: SET COMMAND LIST (SHEET 4 OF 4)
Command Default Description