User`s guide

RN-WIFLYCR-UG
www.rovingnetworks.com Version 1.2r 4/30/13 page 105
set sys sleep <value> 0 Sets the sleep timer.
set sys trigger <flag> or
<mask>
0x1 With this parameter setting, the module wakes from sleep state
using the sensor input 0, 1, 2, and 3.
set sys value <mask> 0x0 Sets the default value of the GPIO pins’ outputs upon
power-up.
set sys wake <value> 0 Sets the automatic wake timer in seconds.
set time address <address> 64.90.182.55 Sets the time server address.
set time enable <value> 0 Tells the module how often to fetch the time from the specified
SNTP time server in minutes.
set time port <value> 123 Sets the time server port number.
set time raw <value> None Allows you to set the RTC raw value from the console in sec-
onds.
set uart baud <value> 9600 Sets the UART baud rate, where <value> is 2400, 4800, 9600,
19200, 38400, 57600, 115200, 230400, 460800, or 921600.
set uart flow <value> 0 Sets the flow control mode and parity.
set uart instant <value> Not applicable Immediately changes the baud rate, where <value> is 2400,
4800, 9600, 19200, 38400, 57600, 115200, 230400, 460800, or
921600.
set uart mode <mask> 0 Sets the UART mode register.
set uart raw <value> Not applicable Sets a raw UART value.
set uart tx <value> Not applicable Disables or enables the UART’s TX pin (GPIO10), where
<value> is 1 or 0.
set wlan auth <value> 0 Sets the authentication mode.
set wlan channel <value>
<flag>
0 Sets the WLAN channel, where <value> is a decimal number
from 1 to 13 representing a fixed channel and <flag> is the
optional character
i (meaning immediate).
set wlan ext_antenna <value> 0 Determines which antenna is active, where <value> is 0 (use
the chip antenna) or 1 (use the U.FL connector).
set wlan fmon <value> 3600 Sets the soft AP mode link monitor timeout threshold for the
associated client device.
set wlan id <string> – Reserved for future. use.
set wlan hide <value> 0 Hides the WEP key and WPA passphrase, where <value> is 0
or 1.
set wlan join <value> 1|0 Sets the policy for automatically associating with network
access points.
set wlan key <value> Not applicable Sets the 128-bit WEP key, where <value> is EXACTLY 26
ASCII chars (13 bytes) in hex without the preceding 0x.
set wlan linkmon <value> 0 (disabled) Sets the link monitor timeout threshold, where <value> is a
decimal number representing the number of failed scans before
the module declares
AP is Lost and de-authenticates.
set wlan mask <mask> 0x1FFF (all chan-
nels)
Sets the WLAN channel mask, which is used for scanning
channels with auto-join policy 1 or 2).
set wlan phrase <string> rubygirl Sets the passphrase for WPA and WPA2 security modes.
set wlan number <value> 0 Sets the WEP key number.
set wlan rate <value> 12 Sets the wireless data rate.
TABLE D-1: SET COMMAND LIST (SHEET 3 OF 4)
Command Default Description