User`s guide

RN-WIFLYCR-UG
www.rovingnetworks.com Version 1.2r 4/30/13 page 103
Appendix D. Command Quick Reference Guide
Tabl e D-1 through Table D-5 provide a listing of all available commands and their
defaults. For more detailed information refer to “Command Reference” on page 9.
TABLE D-1: SET COMMAND LIST (SHEET 1 OF 4)
Command Default Description
set adhoc beacon <value> 102 Sets the ad hoc beacon interval in milliseconds.
set adhoc probe <value> 5 Sets the ad hoc probe timeout in seconds (ad hoc mode only).
set adhoc reboot <value> 0 Sets the reboot timer.
set broadcast address
<address>
255.255.255.255 Sets the address to which the UDP hello/heartbeat message is
sent.
set broadcast backup
<address>
0.0.0.0 Sets the secondary broadcast backup address.
set broadcast interval <mask> 7 Sets the interval (in seconds) at which the hello/heartbeat UDP
message is sent.
set broadcast port <value> 55555 Sets the port to which the UDP hello/heartbeat message is
sent.
set broadcast remote <port> 0 Sets the secondary broadcast port.
set comm $ <char> $ Sets character used to enter command mode to <char>.
set comm close <string> *CLOS* Sets the ASCI string that is sent to the local UART when the
TCP port is closed.
set comm idle <value> 0 Sets the idle timer value in seconds.
set comm match <value> |
<hex>
0 Sets the match character in hex or decimal.
set comm open <string> *OPEN* Sets the ASCI string that is sent to the local UART when the
TCP port is opened.
set comm remote <string> *HELLO* Sets the ASCI string that is sent to the remote TCP client when
the TCP port is opened.
set comm size <value> 64 Sets the flush size in bytes.
set comm time <value> 5 Sets the flush timer.
set dhcp lease <value> 86400 Sets the soft AP mode DHCP lease time in seconds.
set dns address <address> 0.0.0.0 Sets the IP address of the DNS sever.
set dns backup <string> rn.microchip.com Sets the name of the backup host for TCP/IP connections to
<string>.
set dn
s name <string> server1 Sets the name of the host for TCP/IP connections to <string>.
set ftp addr <address> 0.0.0.0 Sets the FTP server’s IP address of the FTP server.
set ftp dir <string> public Sets the starting directory on the FTP server.
set ftp filename <filename> See description Sets the name of the file that is transferred when issuing the
ftp u command, where <filename> is the firmware image.
Firmware version 4.0 default is wifly3-<version>.img (RN131)
wifly7-<version>.img (RN171).
Firmware prior to 4.0 default is wifly-GSX-<version>.img
(RN131) wifly-EZX-<version>.img (RN171).
set ftp pass <string> Pass123 Sets the password for accessing the FTP server.
set ftp mode <mask> 0x0 Sets the ftp mode, where <mask> indicates active or passive
mode. Default is passive.
set ftp remote <value> 21 Sets the FTP server’s remote port number.