User manual

WiFly GSX
WiFlyGSX-um.pdf 12/14/2009
www.rovingnetworks.com
[e-mail]
Phone [phone]
- 17 -
get dns display DNS settings.
get ftp display FTP settings.
get ip display IP address and port number settings.
get mac display the device MAC address.
get optional display the optional settings like device ID
get sys display system settings, sleep, wake timers, etc.
get time display the time server UDP address and port number.
get wlan display the ssid, chan, and other wlan settings.
get uart display the UART settings.
ver return the software release version
7 STATUS Commands
These commands begin with “show”, and they return the current values of variables in the system.
In some cases, for example IP addresses, the current values are received from the network, and
may not match the stored values.
show battery Displays current battery voltage, (only valid for Roving battery powered product like
the RN-370 and temperature sensors)
show connection Displays connection status in this HEX format: 8XYZ
Bit
location
13-16 9-12 7 6 5 4 0-3
Function fixed channel DNS found DNS server Authen Assoc TCP status
Value 8 1-13 1=resolved 1=
contacted
1= OK 1=OK 0= Idle,
1=Connected
3= NOIP
4= Connecting
show io Displays IO pin levels status in this HEX format: 8ABC
Example: show i returns 8103 indicates pins 0, 1 and 9 high level.
show net Displays current network status, association, authentication, etc.
show rssi Displays current last received signal strength.
show stats Displays current statistics, packet rx/tx counters, etc.