User manual

WiFly GSX
WiFlyGSX-um.pdf 12/14/2009
www.rovingnetworks.com
[e-mail]
Phone [phone]
- 16 -
“my$pass$word”. The replacement character can be changed using
the optional command set opt replace <char>.
Example : “set w p password” sets the phrase.
set wlan rate <value> sets the wireless data rate. Lowering the rate increases the effective
range of the WiFly-GSX module. The value entered is mapped
according to the following table
Value Wireless Data Rate
0 1 Mbit/sec
1 2 Mbit/sec
2 5.5 Mbit/sec
3 11 Mbit/sec
4 - 7 Invalid
8 6 Mbit/sec
9 9 Mbit/sec
10 12 Mbit/sec
11 18 Mbit/sec
12 24 Mbit/sec (default)
13 36 Mbit/sec
14 48 Mbit/sec
15 54 Mbit/sec
set wlan ssid <string> sets the wlan ssid to associate with. 1-32 chars.
NOTE: If the passphrase or ssid contain the SPACE ( ‘ ‘)
characters, these can be entered using substitution via the “$”
character.
For example, if the ssid of the AP is “yellow brick road”
You would enter “yellow$brick$road”
Using the ‘get w” command will properly display the value:
SSID=yellow brick road.
set wlan window <value> sets the IP maximum buffer window size. Default is 1460 bytes.
6 GET Commands
These commands begin with “get”. They display the current values.
get adhoc display all adhoc settings.
get broadcast will display the broadcast UPD address, port and interval
get everything displays all configuration settings, useful for debug.
get com display comm. settings.