User manual

WiFly GSX/EZX
www.rovingnetworks.com WiFly-RN-UM 11/9/2011
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 44 ~
10.6. Setting Debug Print levels
There are a number of print functions that can be enabled to assist in debugging the operation and status of
the module. The following command is used to control these printouts.
set sys printlvl <value> sets additional print functions. Value is a bit-mapped register that controls which
printout messages are sent to the UART.
Print level
Description
0
Quiet mode. No messages printed when module wakes up or powers up.
1
All status messages
2
Only critical NETWORK AP connection level status is output, "Associated!" Or
"Disconnect from <ssid>"
4
DHCP and IP address status information Once the configuration has been checked; this
can then be turned off so that these messages do not interfere with the data.
0x4000
New scan format output
0x10
Enables uart heartbeat message. See section 10.6.2 for more details