User manual

WiFly GSX/EZX
www.rovingnetworks.com WiFly-RN-UM 11/9/2011
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 32 ~
ping g pings the gateway, the gateway IP address is loaded if DHCP
is turned on, otherwise it should be set with the set ip gateway <addr>
command
ping h pings the stored host IP address, the host IP address can be set
with the set ip host <addr> command
ping i pings a known Internet server at www.neelum.com by first
resolving the URL (proves that DNS is working and proves the device has
internet connectivity).
ping 0 terminates a ping command
reboot forces a reboot of the device (similar to power cycle)
scan <time> <P> Performs an active probe scan of access points on all 13 channels. Returns
MAC address, signal strength, SSID name, security mode.
Default scan time is 200ms / channel = about 3 seconds.
time is an optional parameter, this is the time in ms per channel.
For example, “scan 30” reduces the total scan time down to about 1
second. This command also works in Adhoc mode. If the optional P
parameter is entered, the module will perform a passive scan, and list all
APs that are seen in passive mode.
sleep Puts the module to sleep mode. The module can come out of sleep mode
by either sending characters over the uart or by using the wake timer.
time Sets the Real time clock by synchronizing with the time server specified
with the time server parameters (see section 5.9) This command sends a
UDP time server request packet.