User manual

WiFly GSX/EZX
www.rovingnetworks.com WiFly-RN-UM 11/9/2011
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 24 ~
5.11. WLAN Parameters
set wlan auth <value> Sets the authentication mode. Not needed unless using auto join mode 2.
i.e. set wlan join 2
Note: During association the WiFly module interrogates the Access Point
and automatically selects the authentication mode.
The current release of WiFly firmware supports these security modes:
• WEP-64 and WEP-128 (open mode only, NOT shared mode)
• WPA2-PSK (AES only)
• WPA1-PSK (TKIP only)
• WPA-PSK mixed mode (some APs, not all are supported)
Value
Authentication Mode
0
Open (Default)
1
WEP-128
2
WPA1
3
Mixed WPA1 & WPA2-PSK
4
WPA2-PSK
5
Not Used
6
Adhoc, Join any Adhoc network
8
WPE-64
set wlan channel <value> sets the wlan channel, 1-13 is the valid range for a fixed channel. If 0 is
set, then scan is performed, using the ssid, for all the channels set in the
channel mask.
set wlan ext_antenna <0, 1> determines which antenna is active, use 0 for chip antenna, 1 for UF.L
connector. Default = 0. Only one antenna is active at a time and the
module must be power cycled after switching the antenna.
NOTE: This command applies only to RN-131. This command is not
applied to the RN-171. Issuing this command on the RN-171 will give an
error message: ERR: Bad Args