User manual

WiFly GSX/EZX
www.rovingnetworks.com WiFly-RN-UM 11/9/2011
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 14 ~
set ftp user <name> sets the ftp user name for accessing the FTP server. Default is roving
set ftp pass <pass> sets the ftp password for accessing the FTP server. Default is Pass123
5.6. IP Parameters
set ip address <addr> sets the IP address of the WiFly GSX module. If DHCP is turned on, the
IP address is assigned and overwritten during association with the access
point. IP addresses are “.” delimited.
Example: set ip a 10.20.20.1
set ip backup <addr> sets a secondary host IP address. If the primary host IP is not reachable
the module will try the secondary IP address if set.
set ip dhcp <value> enable/disable DHCP mode. If enabled, the IP address, gateway, netmask,
and DNS server are requested and set upon association with access point.
Any current IP values are overwritten.
DHCP Cache mode can reduce the time it takes the module to wake from
deep sleep thus saving power. In cache mode, the lease time is checked
and if not expired, the module uses the previous IP settings. If the lease
has expired the module will attempt to associated and use DHCP to get the
IP settings. DHCP cached IP address does not survive a power cycle or
reset.
Mode
Protocol
0
DHCP OFF, use stored static IP address
1
DHCP ON, get IP address and gateway from AP
2
Auto-IP, generally used with Adhoc networks
3
DHCP cache mode, Uses previous IP address if
lease is not expired (lease survives reboot)
4
Reserved for future use