User manual

!
www.rovingnetworks.com Version 1.0r 9/21/2012 28
RN-WIFLYCR-UM
set wlan auth <value>
This command sets the authentication mode, where <value> is shown in Table 11. You only need to set this
parameter if you are using automatic join mode 2, i.e., the set wlan join 2 command.
NOTE: During association the module interrogates the access point and automatically selects the authentication
mode.
The firmware supports he following security modes:
• WEP-64 and WEP-128 (open mode only, NOT shared mode)
• WPA2-PSK (AES only)
• WPA1-PSK (TKIP only)
• WPA-PSK mixed mode (some access points, not all are supported)
Table 11. set wlan auth Command Authentication Modes
Value
Authentication Mode
0
Open (Default)
1
WEP-128
2
WPA1
3
Mixed WPA1 and WPA2-PSK
4
WPA2-PSK
5
Not used
6
Ad hoc mode (join any ad hoc network)
8
WPE-64
Default: 0
Example: set wlan auth 4 // Use WPA2-PSK authentication