User manual

WiFly GSX
www.rovingnetworks.com WiFlyGSX-um 7/16/2010
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 4 ~
1. Overview
The “WiFly” radio module is a complete stand alone embedded wireless LAN access device. The device
has on board TCP/IP stack and applications. Requiring only 4 pins (POWER, TX, RX, GND) to design in.
Once initial configuration is set, the radio can automatically access the WiFi network and send/receive
serial data over UART.
• Fully Qualified and Wi-Fi Certified 2.4GHz IEEE 802.11b/g transceiver
• High throughput, up to 4Mbps sustained data rate with TCP/IP and WPA2
• Ultra-low power (4uA sleep, 40mA Rx, 210mA max Tx)
• Small, compact surface mount module
• On board ceramic chip antenna and U.FL connector for external antenna
• 8 Mbit flash memory and 128 KB RAM
• UART and SPI (future) data/control interfaces
• 10 general purpose digital I/O
• 8 analog inputs
• Real-time clock for wakeup and time stamping/data logging
• Accepts 3.3V regulated or 2-3V battery with on board boost regulators
• Supports Adhoc and Infrastructure mode connections
• On board ECOS-OS, TCP/IP stacks
• Wi-Fi Alliance certified for WPA2-PSK
• FCC / CE/ ICS certified and RoHS compliant
Features
• Host Data Rate up to 1 Mbps for UART, 4Mbps SPI
• Memory 128 KB RAM, 2 MB ROM, 2 KB battery-backed memory, 8 Mbit Flash.
• Intelligent, built-in power management with programmable wakeup
• Can be powered from regulated 3.3VDC source or 2.0-3.0V batteries
• Real time clock for time stamping, auto-sleep and auto-wakeup modes
• Configuration over UART or wireless interfaces using simple ASCII commands
• Over the air firmware upgrade (FTP), and data file upload.
• Secure WiFi authentication WEP-128, WPA-PSK (TKIP), WPA2-PSK (AES).
• Built in networking applications DHCP client, UDP, DNS client , ARP, ICMP ping, FTP, TELNET,
HTTP
• 802.11 power save and roaming functions