User manual

WiFly GSX
www.rovingnetworks.com WiFlyGSX-um 7/16/2010
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 28 ~
However, given the uncertainty of packet delays in a TCP/IP network and the affects of interference and
retries inherent in wireless networks, flow control is usually required whenever large, contiguous quantities
of data are being written to the UART to guarantee no data is lost.
10.5. Setting GPIO direction, Alternate Functions and Disabling LEDs
The direction of the GPIO can be controlled with the GPIO mask using the set sys mask <value> command
to set the GPIO pin direction. Value is entered as a hex number. If you need to set only one bit in the mask
you need to read, mask and set the value. Otherwise you will over write any previous GPIO settings.
The hex value represents a bit mask that controls each pin where 1 = output and 0 = input. For example, set
sys mask 0x0 sets all pins to input.
To set only GPIO 6 and 7 for example, you would enter set sys mask 0xc0
The default mask for WiFly = 0x20f0, which has GPIO 13, 8, 7,6,5,4 as Outputs.
GPIO 0-3 are used internally on the module.
GPIO 4, 5, 6 are LEDs.
GPIO 9 is reserved as the ARM factory reset/adhoc mode, (read at power up) and otherwise general purpose
input detect pin.
GPIO 10, 11 are the Uart RX, TX pins and TX does not need to be masked as an output.
GPIO12 is CTS (input) if used.
GPIO13 is RTS (output) if used.
The get sys command will show the setting of the GPIO mask.
<2.09> get sys
SleepTmr=……
IoFunc=0x0
IoMask=0x21f0