User manual

WiFly GSX
www.rovingnetworks.com WiFlyGSX-um 7/16/2010
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 23 ~
8. Action Commands
$$$ enter command mode Characters are PASSED until this exact sequence
is seen. If any bytes are seen before these chars, or after these chars, in a
250ms window, command mode will not be entered and these bytes will
be passed on to other side.
close disconnect a TCP connection.
exit exit command mode. Exit command mode. “EXIT” will be displayed.
factory RESET Loads factory defaults into the RAM configuration. Note that the
RESET must be capitalized. This command also writes the settings out
to the standard config file. After this command the module then needs to
be rebooted for settings to take effect.
join <ssid> joins the network <ssid>. If network is security enabled you must set the
pass phrase with the set wlan phrase command prior to issuing the join
command
join # <num> join a network from the scan list. <num> is the entry number in the scan
list that is returned from the scan command. If network is security
enabled you must set the pass phrase with the set wlan phrase command
prior to issuing the join command
leave disconnects the module from the currently associated Access Point.
lookup <hostname> performs a DNS query on the supplied hostname.
open <addr> <port> opens a TCP connection to the given IP port and address. If no arguments
are provided, the device will attempt to connect to the stored remote host
IP address and remote port number. <addr> can also be a DNS hostname
and will be resolved if entered.
Ping <g | h | i | addr> <num> ping remote host. Default sends 1 packet. Optional <num> sends <num>
pings at 10 per second.
Ping 10.20.20.12 10 – pings IP address 10 times
ping g pings the gateway, the gateway IP address is loaded if DHCP
is turned on, otherwise it should be set with the set ip gateway <addr>
command