User manual

WiFly GSX
www.rovingnetworks.com WiFlyGSX-um 7/16/2010
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 21 ~
get time display the time server UDP address and port number.
get wlan display the ssid, chan, and other wlan settings.
get uart display the UART settings.
ver return the software release version
7. Status Commands
These commands begin with “show”, and they return the current values of variables in the system. In some
cases, for example IP addresses, the current values are received from the network, and may not match the
stored values.
show battery Displays current battery voltage, (only valid for Roving battery powered product like the
RN-370 and temperature sensors)
show connection Displays connection status in this HEX format: 8XYZ
Bit
location
13-16 9-12 7 6 5 4 0-3
Function
fixed channel DNS found DNS server Authen Assoc TCP status
Value
8 1-13 1=resolved 1=
contacted
1= OK 1=OK 0= Idle,
1=Connected
3= NOIP
4= Connecting
show io Displays IO pin levels status in this HEX format: 8ABC
Example: show i returns 8103 indicates pins 0, 1 and 9 high level.
show net <n> Displays current network status, association, authentication, etc. Optional parameter
displays only the MAC address of the AP currently associated.
show rssi Displays current last received signal strength.
show stats Displays current statistics, packet rx/tx counters, etc.
show time Displays number of seconds since last powerup or reboot
show q <0-7> Display the value of the an analog interface pin from 0 to 7. The value returned will be in
the format 8xxxxx where xxxxx is voltage in microvolts sampled on the channel you
request with the 8 in front as a start marker.