User manual

WiFly GSX
www.rovingnetworks.com WiFlyGSX-um 7/16/2010
809 University Avenue • Los Gatos, CA 95032 • Tel [phone] • [e-mail]
~ 15 ~
set sys autosleep <num> Sets the auto-sleep timer. 0 disables. If the protocol is set to UDP ONLY, this
timer is used as a quick sleep function. Device will sleep
<num> ms after transmission of the first UDP packet.
set sys iofunc <value> sets the IO port alternate functions. Bit-mapped value. For more details
see section 10.5
set sys mask <mask> sets the IO port direction mask. Bit-mapped value. For more information
see section 10.5
set sys printlvl <value> sets numerous print functions. 0 = quiet, 1 = connect information Default
is 1 . Please refer section 10.6 on Setting Debug Print levels
set sys output <value> <mask> sets output PIO pins to HIGH or LOW. Bit-mapped value. Optional
mask only sets a subset of pins.
set sys sleep <secs> sets the sleep timer. 0 disables.
NOTE: If not using Sensor pins to wake the module, be sure to set the
wake timer before issuing the sleep timer or the module will not wake up.
See section 10.1 for more details on using system timers
set sys trigger <value> sets the sensor input(s) to wake on (0-3). Bit-mapped value. 0 disables.
set sys wake <secs> sets the auto wake timer. 0 disables. See section 10.1 for more details on
using system timers
5.9. Time Server Parameters
set time address <addr> sets the time server address. (sNTP servers)
set time port <num> sets the time server port number. Defaults to 123 which is almost always
the sNTP server port.
set time enable <value> Enable or disable fetching time from the specified sNTP time server.
Default=0= disabled. A value or 1 gets time only once on power up. Any
value > 1 gets time continuously every <value> minutes.