User guide

RN Commands Version 4.25, 11/1/2007 Page 19 of 25
809 University Avenue • Los Gatos, CA 95032 • 1-[phone] • [e-mail]
www.rovingnetworks.com
6 Factory Default Power up Settings
Bluetooth Service Profile = Serial Port Profile (SPP)
Device Mode = 0 (Slave)
Baud Rate = 115200bps,Parity=None, Data bits = 8 bits(fixed), Stop bits 1 (fixed).
Power Mode = Auto low power discoverable mode
Name of Device (local name) = FireFlyt-XXXX last 2 bytes of BT address
Service Name = SPP
Service Class=0000 (undefined service type)
Major & Minor Class Of Device (COD) = 0x1F00 (unknown device type)
Authentication Disabled
Encryption Disabled
Discovery Enabled (0x0200 = windowl, fixed interval of 0x800= 1.28 Seconds )
Connection Enabled (0x0200=window, fixed interval of 0x800 = 1.28Seconds)
Bonding Disabled
Config Timer=60 seconds
SNIFF mode disabled
Default PIN = “1234”
Note: PIO(4) Switch 1, Set ON at power up time, and then toggled 3 times will change all
settings above back to their factory values. (except the Device name). Device will reboot
immediately upon detection of this mode.