Specifications

F
196
◆
Not UPS-able;
▲
Hazmat terms apply;
LS
Limited Supply
ANTENNAS &
ELECTRONICS
BUILT IN
SIGNAL
FINDER
SURELOCK™ DIGITAL TV SIGNAL FINDER
Use the SureLock® to pinpoint the location of local TV towers before doing a channel scan for simple, fool-proof
antenna pointing. Greatly reduces set-up time and frustration by eliminating the need for multiple channel scans in
different directions. Simple plug-n-play design connects to any available TV antenna output or may be installed
inline between the antenna and TV. Rotate the antenna until the maximum number of LED’s are illuminated in the
signal meter, then run a channel scan. Variable gain control feature let’s you adjust sensitivity for optimal resolution
in both strong and weak signal areas. For use with any over-the-air TV antenna. 3”H x 3”W x 1”D
.
87572
SureLock Signal Finder #SL1000 40
DIGITAL HDTV ANTENNAS
Upgrade to the latest antenna technology and
get maximum reception of the new digital TV
signals. The sleek, aerodynamic JACK® antenna is
fixed at 11 1/4” high eliminating the need to crank up
or down and is always ready for travel. An amplified,
ultra high gain antenna provides the best digital TV reception
available for your RV with superior reception of both VHF
and UHF signals and a much broader reception range.
The built-in SureLock® Digital TV Signal Finder let’s you
pinpoint the local TV towers before scanning for channels
for simple, fool-proof antenna pointing. Full 360° rotation
allows for precise antenna pointing with no “dead spot” commonly
found with other antenna mounts. An LED light on the head confirms
power to the built-in amplifier via the supplied wall mount power injector
switch. At just 11.25”H x 16”W x 12.5”L, the JACK® is up to 70%
smaller than other antennas and provides superior reception of the new
digital TV signals. Available in black or white.
87581
Jack Antenna, White #OA8200 1
87582 Jack Antenna, Black #OA8201 1
REPLACEMENT HEAD
FOR SENSAR
®
Sensar® is a registered trade-
mark of Winegard® Company.
Jack® is a product of King Controls® and is not affiliated with nor
manufactured by Winegard® Company. Replace your old Sensar®
antenna with the JACK® replacement head for better digital TV recep-
tion. Includes custom bracket for simple retrofit to your current antenna
mast using the existing mounting pins. Broader reception range helps
to receive signals found in the “dead spot” or 35° of rotation not reached
by the existing mount. The amplified antenna can be powered by your
existing antenna power supply or used with the included power injector.
A universal mounting bracket is also included for installation on a pole
or railing for residential use. At just 2.25”H x 16”W x 12.5”D, the JACK®
replacement head is 70% smaller with improved wind resistance and
weighs 25% less than the existing antenna head.
87264
Replacement Head, White #OA-8000 10
ANTENNA POWER INJECTOR SWITCH
Twelve volt DC power supply for amplified antenna with
flush wall mount plate. Inputs for TV antenna and cable with
built-in selector switch. F-type connectors for 2 TV outputs.
87583
Power Supply, White #PB1000 1
87584 Power Supply, Black #PB1001 1
MOUNTING PLATE
Use when replacing existing antenna
to cover all pre-existing screw
holes for a simple water-tight seal.
87711
Mounting Plate
#MB8000
10
* More accessories are
presented on page 215!
In Section F:
Satellite Antennas TV Antennas Antenna Accessories Phone Accessories CB Stereo TV Navigation
KING CONTROLS SATELLITE SYSTEMS