Technical data

Wheel Changing

165

Positioning the jack

NEVER work beneath the

car with the jack as the

only means of support. The jack

is designed for wheel changing

only!

Never jack the car using

any jacking points other

than the designated points

shown. Serious damage to the

car could occur.

Position the jack on firm level ground under the jacking point

nearest the wheel to be removed. Note that the domed head

of the jack must fit into the corresponding recess in the sill

plate (see inset in illustration).

Turning the jack screw by hand, raise the jack until the jack

head fits snugly into the recess in the sill plate. Ensure that the

base of the jack is in full contact with the road surface

H2722