Technical data

Seat Belts

CENTRE REAR BELT (5 door models)

The central rear seating position is fitted with a lap belt only. It is

essential that all slack is removed from the webbing and that the

belt fits snugly AS LOW ON THE HIPS AS POSSIBLE. Fit the

tongue plate into the buckle (marked ‘CENTRE’) nearest the

centre of the seat.

NOTE: The centre belt tongue plate will not latch into either of the outer

seating position buckles.

To unfasten the belt, press the RED button attached to the seat

belt buckle. When not in use, the tongue plate should be clipped

into the socket at the top of the seat (see inset).

Adjusting the belt

To adjust the length of the belt, turn the adjuster at right angles to

the webbing (as shown in the illustration) and then pull the

webbing through the adjuster to the required length.

Once the belt is fastened, the webbing will be ‘locked’ to the

length that has been set.

CENTRE REAR BELT (4 door models)

The central rear seating position is fitted with a three point

shoulder/lap belt similar to the belts fitted to the other seating

positions. Ensure that the shoulder belt passes across the left

shoulder and that the metal tongue plate is inserted into the buckle

nearest the wearer.

HB0142

HB0143