Owner manual

Rover Mowers Limited Ride-on Mower Grass Catcher
The Rover Ride-on Mower Grass Catcher has been designed to be fitted to and used with the Rover Rancher, Raider
and Lawn King, fitted with either the 30" or the 38" pressed steel cutterheads.
The correct model grass catcher to suit the Rover Rancher, Raider and Lawn King models and cutterhead combination
can be selected from the "Grass Catcher Selection Chart" (See Section 1. 1 below).
Some Rover Ride-on Mowers will need to have a towbar fitted and/or the use of a different mount support bracket before
the Rover Grass Catcher can be correctly mounted. These mowers are identified in the chart below by an asterisk *
1. SETTING UP
1.1 Grass Catcher Selection
Cutterhead Catcher Towbar Mount support
Rover Ride-on Mower Model No. Model No. Model No. Model 110 Bracket
Required A12 942
Rancher Selector Drive 17166 180 108 *
198 109
Rancher Selector Drive 27166 180 108 *
198 109 *
Rancher Selector Drive 17188 180 108 *
198 109
Rancher Selector Drive 27189 180 1'08 *
198 109 *
Rancher Auto-Drive 18166 180 108 *
198 109
Rancher Auto-Drive 28166 180 108 *
198 109 *
Rancher Auto-Drive 18188 180 108 *
198 109
Rancher Auto-Drive 28189 180 108 *
198 109 *
Rancher H dro 28266 180 108 *
Raider 4078 180 108
Lawn King Hydro 2950 180 108
198 109
WARNING
The Rover Grass Catcher Models 108 and 109 are designed for
front engine ride-on mowers ONLY!
DO NOT FIT lO8/l09 Grass Catchers to rear engine mowers.
Before proceeding with the assembly of the grass catcher, remove the loose parts kit from the carton.
1.2 Loose parts kit – Model 108 (30” Cutterhead) 1.3 loose parts kit – Model 109 (38” Cutterhead)
Item No. Su lied
Transfer tube 1
Chute assembly 1
Rod-outlet chute
1
Fan disks assembly 1
Grass catcher assembly 1
Support bracket 1
Owner's manual 1
Side frame 2
Spreader 1
Bolt - 3/8 x 1" unc. 2
Nycloc nut - 3/8" unc. 3
Nyloc nut –
¼
" unc. 4
Screw -
3
/16' x 1" unc. RH. 4
Nyloc nut -
3
/16' unc. 4
Washer - 3/8" flat
2
Item No. Su lied
Transfer tube 1
Chute assembly 1
Rod-outlet chute 1
Grass catcher assembly 1
Support bracket 1
Owner's manual 1
Side frame 2
Spreader 1
Bolt - 3/8 x 1" unc. 2
Nyloc nut - 3/8" unc. 3
Nyloc nut –
1
/4" unc. 4
Screw -
3
/16' x 1" unc. RH. 4
Nyloc nut -
3
/16' unc. 4
Skirt 1
Bolt-
5
/16' x ¾" cuphead 2
Washer -
5
/16' flat 2
Nyloc nut -
s
/16" unc. 2
Washer - 3/8" flat 4