Users Manual

PARKING MODE
ROVE R3 Hardwire Kit installation is required for this feature.
Purchase the HWK separately by visiting
www.rovedashcam.com
Parking Monitor allows you to record video when your car is
parked and you are away from it. The dash cam needs power
from your car’s battery and fuse box.
This feature is designed to work when camera is SHAKEN
during Hit-&-Run event while your car is parked. When
someone hits your car and shaking is detected based on your
G-sensor setting, the camera Will turn ON automatically > then
ROVE R3 dash cam does NOT have internal battery. Therefore
for parking mode feature to work, the dash cam needs power
when you are parked and away from your car. Therefore to get
this power supply, Hardwiring Kit is required separately to
connect the dash cam to car’s fuse box to get the power form
your car’s battery.
Never connect the dash cam directly to your car’s 12/24V battery
by modifying wires. The dash cam is not designed to handle
direct current from the battery. It needs a step-down circuit in the
middle (Hardwire Kit) to adjust the current required by the dash
cam. You must connect the dash cam using the ROVE’s 3-Lead
Hardwire Kit and connect it to the car’s fuse box (NOT to battery
terminals directly).
CAUTION
NOTE
The camera has a built in temperature sensor. During sunny afternoon
and direct sunlight with locked car, the inside of the car turns into a
greenhouse effect, and depend on your geographical location the
temperature can exceed the recommended guidelines for this product.
When this happens, the camera will automatically shut down to
prevent damage to the unit. (See pg. 13 for temperature guidelines)
43