Product Manual

STAINLESS STEEL WORK TABLE OWNER’S MANUAL STAINLESS STEEL WORK TABLE OWNER’S MANUAL
8. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
• Whilst you attempt to remove all sharp edges, care must be taken when cleaning or handling
the table to prevent the risk of injury from exposed metal edges.
•
Do not overload the table causing the top or shelf to bend.
INSTALLATION
Parts List- See Fig. 1
Please inspect box contents to ensure all
components listed as below are received.
A. Stainless Steel Table Top X 1
B. Galvanized Shelf X 1
C. Galvanized Legs X 4
D. Hex Screws X 16
E. Allen Key X 1
Assembly – See Fig. 2
Step 1
Carefully remove all of the parts from the carton.
Step 2 Place Tabletop (A) upside-down on soft cloth surface to prevent scratches.
Step 3 Insert Legs (C) into the round slots on the bottom of the Tabletop (A).
NOTE: Do NOT tighten the Legs into the Tabletop.
Step 4
Slide the Galvanized Bottom Shelf (B) over each Leg (C) and tighten the Hex Bolts (D)
when your desired height is achieved. Use the Allen Key (E) to tighten the Hex Bolts (D) to fix the
Galvanized Bottom Shelf (B) to Legs (C).
Step 5 Use the Allen Key (E) to tighten the Hex Bolts (D) to fix Legs (C) to Tabletop (A).
Step 6 Adjust the Legs (C) so that they are level and firmly located in each socket. Tighten all
screws on Tabletop (A) and the corner of the Galvanized Bottom Shelf (B).
2 of 3
CAUTION: Please make sure the Hex Bolts (D) are fully tightened in order to fully support
recommended weight capacity.
Step 7 Turn the table over and set it upright. If there is any movement in the table, the feet can
be used to make adjustment and level the table ready for use.
NOTE: Before using the table, we recommend that you clean it thoroughly using a cleaning
agent recommended for stainless steel, ensuring all cleaning agents and moisture are removed
from the table top before use.
MAINTENANCE
• Clean the table regularly as required, using a cleaning agent recommended for stainless steel
and galvanized surfaces.
• Always clean off any cleaning solution residue, as failure to do so may cause discolouring and
marks to develop.
• Never leave any surface with water or damp areas, as this may cause discolouration.
WARRANTY
One-Year Limited Warranty
Distributed by
Northern Tool + Equipment Co., Inc.
Burnsville, MN 55306
NorthernTool.com
Made in China
3 of 3
D
E
A
B
C
Stainless Steel Tabletop - x1
Galvanized Shelf X 1
Galvanized Legs X 4 legs and Feet Levelers - x4
(Table Legs ship with Feet Levelers screwed into the Legs)
Hex Screws X 16
Fig. 1
Fig. 2
Allen Key X 1
C
A
B
D
E