Product Manual

Page 8 of 12
3. Shut-off valve is not fully open
4. Foreign material is jammed in
the metering element
2. Relief the pressure
3. Fully open the shut-off valve
4. Loosen swivel fitting (part# 1-1 of
control valve), and clean up foreign
material
Oil leaks from swivel
1. Swivel is loose
2. O-ring is worn or damaged
1. Tighten the swivel (part# 1-1 of
control valve)
2. Replace the o-ring (part# 1-14 of
control valve)
Oil drips from nozzle
Nozzle is damaged or obstructed
Inspect the nozzle for damage or
obstructions, and replace if damaged
Valve leaks
O-rings or valve seat are worn or
damaged
Replace the o-rings (part# 1-5 of control
valve) and/or the valve seat (part# 1-10
of control valve)
Leakage from meter
O-ring damaged
5. 1. Get the meter off from the dispense
system
6. 2. Take off the Rubber Protector
(part# 3-4 of control valve) and Front
Label (part# 3-6 of control valve)
7. 3. Remove four the socket head cap
screws (part# 3-8 of control valve)
on the cover of the meter
8. 4. Remove eight the hex bolts (part#
3-18 of control valve) on the bottom
of the meter
9. 5. Take off the seat( part# 3-10 of
control valve)
10. 6. Check the o-ring (part# 3-1 of control
valve), replacing the o-ring if it is
damaged
11. 7. After replacing the o-ring, assemble
the meter and fix it back to the
dispense system
No display
Battery out of power
Replace the battery
Wrong reading
Wrong correction factor
Follow “CALIBRATION PROCEDURE”
for right correction factor
MAINTENANCE
CAUTION: Remove all tension before servicing. Hazards or unsafe practices MAY result in minor
personal injury, product or property damage.
WARNING: Before performing any service, always disconnect and lock out compressed air or
fluid, and remove all spring tension. Hazards or unsafe practices COULD result in severe personal
injury or death.
WARNING: User servicing of the reel is limited to replacing input/output hoses only. Refer all other
repairs to an authorized service person. Failure to do so can result in personal injury and/or equipment
damage and may void the warranty.
Replacing the hose
To remove the hose
①. Pull out the hose leaving 2 to 3 feet on the spool. Engage the latch pawl.
②. Unthread the hose at the connection to the swivel tube.
③. Remove the hose.
To install the hose