Product Manual

Page 3 of 12
 Check the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. Do not
repair high-pressure couplings. You must replace the entire hose.
INSTALLATION
Typical installation refers to Fig.1.
Fig. 1
NOTE: The above typical installation is only for reference. It may be different from your actual system design.
WARNING: If this is a new installation, or if the oil in the lines is contaminated, flush the lines before you
install the kit. No impurities or contaminant are allowed to enter the kit.
WARNING: To reduce the risk of serious injury, the pressure release should be concerned. Please
follow the Pressure Relief Procedure in OPERATION INSTRUCTIONS section for the release process.
WARNING: To reduce the risk of static sparking, effectively ground all of this equipment.
NOTE: Use oil resistant pipe sealant or Teflon® Tape on all fitting threads.
1. INSTALLATION OF HOSE REEL
WARNING: Before mounting the hose reel, ensure that the supply line pressure does not exceed the
maximum working pressure of the hose reel.
Unpack and inspect reel for damage. Turn by hand to check for smooth operation. Check for completeness.
Position the reel on the floor, wall or ceiling. Secure into place using four mounting bolts (NOT INCLUDED).
See Fig. 2.
NOTE: Depending on where the reel is placed, it may be necessary to adjust the hose bumper and guide arm
to use the hose properly. See the instructions on the next page to adjust the hose bumper and reposition the
guide arm.