Product Manual

Page 2 of 12
4. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger
industrial equipment. There are certain applications for which this equipment was designed. It will do the
job better and more safely at the capacity for which it was intended. Do not modify this equipment, and
do not use this equipment for a purpose for which it was not intended.
5. Use proper eye protection when assembling and using the kit.
6. Check for damaged parts. Before using this product, carefully check that it will operate properly and
perform its intended function. Check for damaged parts and any other conditions that may affect the
operation of this product. Replace damaged or worn parts immediately.
7. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury,
etc.
8. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating this equipment may result in serious personal injury.
9. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
WARNING: To prevent personal injury, perform Pressure Relief Procedure before and after
operating the control valve and before performing any disassembly or assembly.
WARNING: No complying with below requests will result in severe harm to your body even death.
1. EQUIPMENT MISUSE HAZARD: Equipment misuse can cause the equipment to rupture or malfunction
and result in serious injury.
 Only trained or authorized people should operate this kit.
 Read all instruction manuals, tags, and labels before you operate this equipment.
 Use the equipment only for its intended purpose. If you are not sure, call the distributor.
 Do not modify this equipment. If you need to replace the parts, use the standard parts or
components.
 Check equipment daily. Repair or replace worn or damaged parts immediately.
 Do not exceed the maximum working pressure of the lowest rated system component. This
equipment has a 1500 PSI maximum working pressure.
 Make sure all application comply with local, state, and national fire, electrical, and safety regulations.
 Use fluids and solvents that are compatible with the equipment wetted parts. Refer to the Technical
Data section of all equipment manuals. Read the fluid and solvent manufacturer's warnings.
 Do not move or lift the equipment when the control valve is in use.
 The operation environment must be fireproof, safety electric use and other security assured.
2. SKIN INJECTION HAZARD: Fluid from the control valve, leaks, or ruptured components can splash into
your body, eyes or skin, which may cause extremely serious injury. If this happens, ask for medical help
immediately.
 Do not point the dispensing valve at anyone or at any part of the body.
 Do not stop or deflect leaks with your hand, body, glove or rag.
 Do not use oil that has been polluted.
 Do not put your hand or fingers over the fitting coupler.
 Follow the Pressure Relief Procedure in the OPERATION INSTRUCTIONS section if the grease
fitting coupler clogs and before you clean or service this equipment.
 Before each use, make sure that all connections are properly installed. Tighten all fluid connections
before operating the equipment.