Product Manual

Page 9 of 12
①. Route the hose through the guide arm rollers and opening of the spool. Apply thread tape or sealant to
hose threads.
②. Screw hose fitting into threaded fitting on swivel. Tighten connection with a wrench on fitting. Install
stopper on working end of hose if required.
③. Disengage latch pawl and allow hose to retract.
Replacing the swivel
①. If the swivel leak, replace the O-ring or seal (#31) and washer (#30) by removing the lock washer (#40)
and the part of the swivel shift.
②. If the balls (#37) wear out, replace by removing the lock washer (#40).
③. Replace the new seal by clipping the lock washer (#40). Replace the part of the swivel shift by clipping the
lock washer (#40).
Transportation
When the control valve is in transit, do not exposure the control valves with direct sunlight and avoid rain,
falling, erosive substance, etc.
Storage
①. Store the control valve in a dry place with good ventilation. Do not expose it to excessive heat, humidity or
sunlight. Never let it touch any corrosive substances.
②. Store it out of the reach of children.
Fig. 5