Product Manual

Page 3 of 13
4. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger
industrial equipment. There are certain applications for which this equipment was designed. It will do the
job better and more safely at the capacity for which it was intended. Do not modify this equipment, and
do not use this equipment for a purpose for which it was not intended.
5. Check for damaged parts. Before using this product, carefully check that it will operate properly and
perform its intended function. Check for damaged parts and any other conditions that may affect the
operation of this product. Replace damaged or worn parts immediately.
6. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury,
etc.
7. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating this equipment may result in serious personal injury.
8. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
DANGER
Electrical shock hazard.
Electrical wiring should be done by a licensed electrician in
compliance with local, state and national electrical code,
ANSI/NFPA 70, 30, 30A as appropriate.
Proper ground must be provided to avoid the possibility of
electrical shock. Failure to comply with this warning could
result in serious injury and/or loss of property.
WARNING: Improper use or installation of this product can cause serious bodily injury or death.
NOT FOR USE WITH LIQUIDS AS GASOLINE, ALCOHOL, EXPLOSIVES, CORROSIVES AND
FLAMMABLE, ALIMENTARY LIQUIDS.
Do not use the unit in an explosive environment.
Do not use the unit next to flammable liquids (gasoline, alcohol, etc.).
Do not use the unit in closed environments in presence of gasoline, LPG, methane fuelled vehicles.
Always wear suitable clothes and use suitable protective devices when cleaning, especially when removing
dust or waste. Use aspirators as needed.
Never place hands or limbs under moving parts.
Disconnect power to pump before servicing pump.
NEVER overload.
OPERATING CONDITIONS
1. ENVIRONMENTAL CONDITIONS
Temperature：Min 14°F (-10°C) / Max +140°F (+60°C)
Relative Humidity: Max 90%
WARNING:
The temperature limits should be applied to the pump components and must be respected to avoid possible
damage or malfunction.