Product Manual

Page 11 of 15
3. Wrap the pulled hose one time around the drum to increase tension or un-wrap hose one time
from drum to decrease tension.
4. Re-insert hose through guide, and install stopper onto hose end.
5. Unlatch the drum and check tension. Pull hose from reel, and adjust stopper position, if
necessary.
Replacement of Swivel Seal
1. Turn off and disconnect supply line from swivel inlet.
2. Remove swivel assembly from reel axle.
3. Remove circlip from swivel, and take apart. Note: You may want to remove swivel from reel hose
end, but this is not necessary unless a new swivel is being installed.
4. Replace the seals and reassemble swivel.
5. Use Teflon type or thread sealant on swivel thread fitting, reconnect the swivel thread fitting with
axle.
6. Re-connect inlet supply line.
Replacement of Hose
1. Turn off supply to reel.
2. Pull out all the old hose and lock the reel in this position. Make sure reel drum is securely
locked and cannot rotate back.
3. Remove two hose clamps from the hose.
4. Carefully disconnect hose from swivel joint on side of reel, or male fitting in axle center and
remove old hose.
5. Feed new hose through guide and opening in drum, and connect to swivel. Re-install two hose
clamps, on inside and outside of drum flange. Install stopper on other end of hose in the same
position as before.
6. Carefully release the drum latch, and slowly allow the hose to wind onto the reel. Note: Final
spring adjustment is accomplished by adding or removing wraps of hose around the drum (see
spring tension adjustment).
After Each Use
⚠WARNING
 Bleed fluid/gas pressure from the reel before servicing.
 Use soap and water when checking for air leaks. Exposure of skin directly to pressurized air or
fluids could result in severe bodily injury, including blood poisoning.
Maintenance
Maintain your reel. It is recommended that the general condition of any tool be examined before it is
used. Keep your reel in good repair by adopting a program of conscientious repair and maintenance
in accordance with the recommended procedures found in this manual.
 If the rewind spring fails, for safety reasons, it is strongly recommended the replacement of the
spring canister should be performed by an authorized service technician. The spring can be
under high tension and accidental release can cause severe personal injury.
 User servicing of the reel is limited to replacing input/output hoses and swivel maintenance only.
Refer all other repairs to an authorized service technician. Failure to do so can result in
person injury and/or equipment damage and may void the warranty.
 Use soap and water when checking for air leaks.