Product Manual

Page 7 of 9
the metering element
clean up foreign material
Oil leaks from swivel
1. Swivel is loose
2. O-ring is worn or damaged
1. Tighten the swivel (part# 1-1)
2. Replace the o-ring (part# 1-14)
Oil drips from nozzle
Nozzle is damaged or obstructed
Inspect the nozzle for damage or
obstructions, and replace if damaged
Valve leaks
O-rings or valve seat are worn or
damaged
Replace the o-rings (part# 1-5) and/or
the valve seat (part# 1-10)
Leakage from meter
O-ring damaged
5. 1. Get the meter off from the dispense
system
6. 2. Take off the Rubber Protector (part#
3-4) and Front Label (part# 3-6)
7. 3. Remove four the socket head cap
screws (part# 3-8) on the cover of
the meter
8. 4. Remove eight the hex bolts (part#
3-18) on the bottom of the meter
9. 5. Take off the seat( part# 3-10)
10. 6. Check the o-ring (part# 3-1), replacing
the o-ring if it is damaged
11. 7. After replacing the o-ring, assemble
the meter and fix it back to the
dispense system
No display
Battery out of power
Replace the battery
Wrong reading
Wrong correction factor
Follow “CALIBRATION PROCEDURE”
for right correction factor
MAINTAINANCE
Transportation
When the control valve is in transit, do not exposure the control valves with direct sunlight and avoid rain,
falling, corrosive substance, etc.
Storage
①. Store the control valve in a dry place with good ventilation. Do not expose it to excessive heat, humidity or
sunlight. Never let it touch any corrosive substances.
②. Store it out of the reach of children.