TURBINE DIGITAL METER OWNER’S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing a Roughneck™ Product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This meter is designed for certain applications only. The distributor cannot be responsible for issues arising from modification.
job better and more safely at the capacity for which it was intended. Do not modify this equipment, and do not use this equipment for a purpose for which it was not intended. 5. Check for damaged parts. Before using this product, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of this product. Replace damaged or worn parts immediately. 6. Do not overreach.
2. LCD DISPLAY The “LCD” of the meter features two numerical registers and various indications displayed to the users as below: Fig. 1 INDICATIONS ① Partial register (5 figures with moving comma from 0.1 to 99999) Indicate the volume dispensed since the reset button was last pressed.
DAILY USE The meter turns on automatically when fluid flow starts and turns off automatically shortly after flow stops to conserve power. It can also be turned on manually by pressing and releasing the MENU/ RESET button. 1. Make sure there is no air in the system by starting the flow until it runs steadily. Then, stop the flow using a valve or nozzle. 2. If desired, press the RESET key to zero the meter’s Present Total. When zeros appear, release the button. 3.
DISPLAY CURRENT CORRECTION FACTOR AND GENERAL TOTAL (See Fig. 4) Press MENU and RESET together and hold for two seconds. Value “1.4000” is the correction factor which can be reset; “1234567” is the general total which cannot be reset. Fig. 4 CHANGE MEASUREMENT UNIT (See Fig. 5) Press MENU and RESET together and hold for five seconds or until Zone ⑦ on the display shows the current unit. Press RESET to choose a different measurement unit.
3 Press the MENU key. Keep it pressed until screen displays an image similar to the image shown. The first digit of the top display will flash to indicate the meter is in correction factor modification mode. 4 Press the RESET key to choose the desired digit from 0 to 9. Press the MENU key to start the next digit. Each digit of the correction factor can be changed individually. 5 Make sure the correction factor is correct, then press the MENU key.
5 Make sure the correction factor accurate, then press the MENU key. Keep it pressed until calibration is finished and the factor is saved. The meter will then return to standby.
DIAGRAM AND PARTS LIST No Description Qty. 1 Meter Cover 1 2 Protective Rubber Sleeve 1 3 Electric Board 2 4 Self tapping screws ST2.9X6.5 3 5 Self tapping screws ST2.2X9.5 2 6 Battery Holder 1 7 Battery CR2 1 8 Meter Body 1 9 Self tapping screws ST2.
12 Bearing holders 2 13 Snap Rings 2 14 Circuit Board 1 15 Self tapping screws ST2.9X6.5 2 16 Adapters 2 For replacement parts and technical questions, please call 1-800-222-5381. WARRANTY One-Year Limited Warranty Distributed by Northern Tool + Equipment Co., Inc. Burnsville, MN 55306 NorthernTool.
