Product Manual
Page 2 of 8
2. Keep children away from work area. Do not allow children to handle this product.
3. Store idle equipment. When not in use, tools and equipment should be stored in a dry location to
inhibit rust. Always lock up tools and equipment, and keep out of reach of children.
4. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger
industrial equipment. There are certain applications for which this equipment was designed. It will do the
job better and more safely at the capacity for which it was intended. Do not modify this equipment, and
do not use this equipment for a purpose for which it was not intended.
5. Check for damaged parts. Before using this product, carefully check that it will operate properly and
perform its intended function. Check for damaged parts and any other conditions that may affect the
operation of this product. Replace damaged or worn parts immediately.
6. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury,
etc.
7. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating this equipment may result in serious personal injury.
8. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
To ensure safe and efficient operation, it is essential to read each of these warnings and precautions, and to
follow all instructions listed in this manual.
Improper use or installation of this product can cause serious bodily injury or death.
The nozzle is not a flammable fluid one. DO NOT use with fluid with a flashpoint below 100℉ such as
gasoline and alcohol.
Do not exceed 50PSI line pressure.
DO NOT REMOVE PC BOARD. Damage to LCD could occur, and warranty is void.
This product is not suited for use with fluids for human consumption, including potable water.
Observe precautions against fire or explosion when dispensing fuel. Do not operate the meter in the
presence of any source of ignition including running or hot engines, lighted cigarettes, gas or electric
heaters.
Any components such as hose, nozzle, or pump added to the nozzle must be statically grounded.
Avoid prolonged skin contact with fuels. Use protective goggles, gloves, and aprons in case of accidental
splashing or spillage. Change saturated clothing and wash skin contact areas promptly with soap and
water.
Do not submerge the meter.
INTRODUCTION
1. FLUID COMPATIBILITY
The liquids compatible with Auto shut off digital nozzle must be at low viscosity, namely as below:
- diesel fuel
- kerosene
WARNING: Using with other fluids may cause the reading inaccurate and can damage the nozzle.
WARNING: Not for commercial use.
2. LCD DISPLAY