Product Manual

Page 1 of 8
Thank you very much for choosing a Roughneck
®
product! For future reference, please complete the owner’s
record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty, and these instructions. It is important that you read the entire manual to become
familiar with this product before you begin using it.
This meter is designed for certain applications only. The distributor cannot be responsible for issues arising
from modification. We strongly recommend this meter is not modified and/or used for any application other
than that for which it was designed. If you have any questions relative to a particular application, DO NOT use
the meter until you have first contacted distributor to determine if it can or should be performed on the
product.
For technical questions, please call 1-800-222-5381.
WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow
the safety rules and other basic safety precautions may result in serious personal injury.
Save these instructions in a safe place and on hand so that they can be read when required. Keep
these instructions to assist in future servicing.
TECHNICAL SPECIFICATIONS
Product number
#55692
Flow rate
Up to 60LPM/ 16GPM
Max. operating pressure
3.5 bar/ 50PSI
Operating temperature
-15℃ ～ +60℃/ 5℉ ～ 140℉
Accuracy
±1%
Fluid type
Diesel & kerosene
Screen
5-Digit present total (0.01～999.99)
7-Digit non-resettable total (1～9999999)
Unit of measure
Liter, gallon, pint, quart
Inlet
3/4in.
Outlet
15/16in.
Power supply
2 x AAA
GENERAL SAFETY REGULATIONS
WARNING: Read and understand all instructions. Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions or situations that could occur. It must be understood by the operator that
common sense and caution are factors that cannot be built into this product, but must be supplied by the
operator.
1. Keep the work area clean and dry. Damp or wet work areas can result in injury.